6
Preparation Of Mower
NOTE:
The mower deck PTO belt must be removed
from the electric clutch before continuing with the
installation. Refer to your mower’s owner’s manual for
instructions on PTO belt removal.
From the underside of the engine, disconnect the wiring
harness attached to the electric clutch. Remove the bolt,
washer and electric clutch from the mower. Refer to
Figure A & B.
Once the clutch is removed, install the Engine Pulley
Bushing to the underside of the clutch as shown in
Figure C. The Engine Pulley Bushing must be installed
using an arbor press or equivalent. During installation,
opposite bearing inner race must be supported or
bearing damage may occur.
Once the Engine Pulley Bushing is attached, align the
Engine Pulley center cutout to the bottom of the Engine
Pulley Bushing. Fasten the Engine Pulley Assembly
using (1) Clamp Washer, (1) Lock Washer, and (1) Hex
Bolt. Torque the bolt to 55 ft./lbs. The added Engine
Pulley Assembly will power the collection system and
should resemble Figure E when installed.
Section II - INSTALLATION FOR USE
Remove Bolt
Washer
Figure A
Remove 7/16”-20
Bolt & Washers
Figure B
PRESS
Engine Pulley Bushing Installation
Figure C
Electric Clutch
Engine Pulley Assembled Into Electric Clutch
Figure E
Figure D
Engine Pulley
Bushing
Pulley
Bushing
Number
Located
Under
Bushing
Hex Bolt
Lock Washer
Clamp Washer
Engine Pulley
