Dok. Nr. R60744_Index 1a
Page 14 / 27
5.5.
Edit Parameter
The „Edit Data“‐ menu can be found as follows:
Safety Unit
Load Data From …
Edit Data …
Display Unit
Edit Data …
After choosing the device to be edited in the first menu level, which is followed by the
selection of „Edit Data“, the selectable parameter‐groups are shown. All respective
parameters are listed here (see chapter 6).
The selection menu of the parameter‐group can be
reached in the menu option „Edit Data“. After
confirmation by pressing OK, the respective parameter‐
groups are shown in the display.
Please select the parameter to edit by using the arrow
buttons. The actual value of the parameter is also shown
display. After pressing OK, the parameter can be edited.
By using the arrow buttons left/right, the cursor can be
skipped to another position (the relevant number
flashes). By using the arrow buttons up/down, the value
can be changed. Press OK to confirm or C to leave the
entry.
After changing parameters these must be saved.
This is important to ensure, that the changes took effect also after power‐off or when
the SMCB.1 has been removed from the safety unit (see chapter 5.6).
Parameter changes of the safety unit are only effective after saving (see
5.6.1).