KTR Kupplungstechnik
GmbH
D-48407 Rheine
DATAFLEX
®
85/...
Torque Measuring Shaft
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
49012 EN
17 of 18
6
Please note protection
mark ISO 16016.
Drawn: 03.09.13
Pz/Koe
Replaced
for:
KTR-N valid from 28.05.13
Verified:
22.10.13 Pz
Replaced by:
4 Assembly
4.10 Technical description
Illustration 23.1
Illustration 23.2
!
C A U T I O N !
With saving all of the old data will be overwritten.
A T T E N T I O N !
The calibration can be interrupted if the measurement device is switched off for a short
time and then switched on again. The previously saved parameters will then be
reproduced.
The safe measurement operation can be carried out after saving the new parameters
(point 7) or after interrupting the power supply.
After saving the new parameters (point 7) the parameters will stay the same even if the
power supply is interrupted.
4.11 Services, customer service addresses
If requested we are pleased to perform the calibration of your torque measuring shaft and other services.
Contact addresses of the KTR partners for spare parts and orders can be obtained from the KTR homepage at
www.ktr.com.
A T T E N T I O N !
KTR does not assume any liability or warranty for the use of spare parts and accessories
which are not provided by KTR and for the damages which may incur as a result.