REVOLEX
®
KX / KX-D
Operating/Assembly instructions
Type AB
KTR-N
Sheet:
Edition:
49413 EN
13 of 22
6
Please observe protection
note ISO 16016.
Drawn:
2019-05-29 Pz
Replacing:
KTR-N dated 2016-11-08
Verified:
2019-06-12 Pz
Replaced by:
Unbored/pilot bored hubs are supplied without
balancing. If balancing is necessary subject to the
application, it should be made on completion of the
finish bore. The balancing bores have to be made in
the positions marked in illustration 10.
Illustration 10
!
The balancing bores have to be made
between the pin bores in every case.
We recommend to inspect bores, shaft, keyway and feather key for dimensional accuracy
before assembly.
Heating the hubs lightly (approx. 80 °C) allows for an easier mounting on the shaft.
STOP
Touching the heated hubs causes burns.
Please wear safety gloves.
!
With the assembly please make sure that the distance dimension E (see table 1 and 4) is
observed so that the hubs are not in contact with each other during the operation. The
motor shaft has to be located in the magnetic center. Disregarding this advice may cause
damage to the coupling.
!
With the assembly of screw connections only those screws specified by the manufacturer
have to be used. When tightening the screws the torque specified by the manufacturer has
to be observed. The screws have to be secured against working loose, e. g. by
conglutinating with Loctite (average strength).
STOP
In order to avoid any injuries please always make use of proper lifting equipment.
There are tapped holes on the face and outside diameter of the coupling serving for using proper sling gears or
lifting equipment, respectively. If proper sling gears are used they should be dismounted after assembly of the
coupling.
4
Assembly
4.3 Advice for finish bore
4.4 Assembly of the coupling (general)
