KTR-STOP
®
XS-xx-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
44536 EN
10 of 25
3
Please observe protection
note ISO 16016.
Drawn:
2020-03-26 Shg/Wie
Replacing:
KTR-N dated 2017-12-19
Verified:
2020-03-26 Shg
Replaced by:
KTR supplies brake pads free from asbestos and lead only.
If requested, we will provide you with the respective certificates.
The brake pads are each adapted to the application and delivered accordingly.
They can be distinguished as follows:
•
organic material
•
powder metal
!
Brake pads made of organic material are highly sensitive to grease and oil which means
that they cannot be cleaned. Brake pads having such kind of dirt need to be replaced and
disposed of.
In contrast to organic brake pads, brake pads made of powder metal can be cleaned from grease and oil as long
as they have not fully soaked with grease and oil.
We would recommend to store the brake pads in their package as long as possible to
protect them from any kind of dirt.
!
Brake pads which have worn off to the wear limit have to be replaced immediately. Please
make sure to replace by original parts only.
STOP
In order to avoid any injuries please always make use of proper lifting equipment.
A thread M8 is located on the back of the brakes to fasten an eye bolt serving to use lifting tools. The eye bolt is
to be dismounted after assembly of the brake and stored in a safe place.
!
In order to avoid any damages on the brake, never twist a rope or any other lifting tool
around damageable components such as sensors, centering systems, etc.
Before you start with the assembly please check if a sensor has been mounted.
Please remove it before assembly in order to avoid any damages.
•
Inspect the position of the setting nut (component 1.7). If necessary, set it to the right dimension (see
illustration 17).
•
Insert the brake pads (component 5) fully into the brake caliper.
If you want to use brake pads after having assembled the brake, it is necessary to
disassemble the pad holder (component 1.10 and 1.22) for that purpose (chapter 5.1).
•
Secure the brake pad at the bottom via the spring clamps (component 6) and the cap screws (component 7).
•
Mount the pad retraction set (component 8) by screwing the pin (component 8.1) into the brake pad against a
stop.
4
Assembly
4.3 Brake pads
4.4 Assembly of the brake
