KTM Freeride 350, Owner'S Manual

Page: 80 / 113

ELECTRICAL SYSTEM
78
13.9
Checking the headlight setting
0 0 A A
0 0 B B
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance
A
away from the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. ( p. 78)
13.10
Adjusting the headlight range
Preliminary work
–
Check the headlight setting. ( p. 78)
B01043-10
Main work
–
Adjust the beam distance of the headlight by turning screw
1
.
Guideline
For a motorcycle with rider, the light/dark boundary must be exactly on the lower
mark (the mark is created in: Checking the headlight setting).
Info
Turn clockwise to increase the headlight range, turn counterclockwise to
reduce the headlight range.
A change in weight on the vehicle may require a correction of the headlight
range.
13.11
Changing the speedometer battery
Preliminary work
–
Remove the headlight mask with the headlight. ( p. 76)
B01133-10
Main work
–
Remove screws
1
.
–
Pull the speedometer out of the bracket from above.
B01134-10
–
Using a coin, turn locking cap
2
counterclockwise all the way and remove it.
–
Remove speedometer battery
3
.
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) ( p. 98)
–
Check that the O-ring of the locking cap is seated properly.