KTM Freeride 350, Owner'S Manual

Page: 59 / 113

SERVICE WORK ON THE CHASSIS
57
10.43
Correcting the fluid level of the hydraulic clutch
Info
The fluid level rises with increasing wear of the clutch facing discs.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
B01082-11
–
Remove screws
1
.
–
Remove cover
2
with membrane
3
.
–
Check the fluid level.
Fluid level below container rim 4 mm (0.16 in)
» If the fluid level does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
Brake fluid DOT 4 / DOT 5.1 ( p. 103)
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
10.44
Changing the hydraulic clutch fluid
x
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
B01082-11
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
1
.
–
Remove cover
2
with membrane
3
.
B01083-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
p. 103)
–
On the clutch slave cylinder, remove bleeder screw
5
and mount bleeding
syringe
4
.
B01084-10
–
Remove screw
6
with the O-ring.
–
Inject the liquid into the system until it escapes from opening
A
of the master
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Mount and tighten screw
6
with the O-ring.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim 4 mm (0.16 in)
–
Position the cover with the membrane. Mount and tighten the screws.