13
BRAKE SYSTEM
62
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
B01696-10
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
.
–
Remove cover
with membrane
.
B01697-10
–
Remove screws
and spacers.
–
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc. Carefully pull the brake caliper backwards from the brake disc..
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
B01698-10
–
Remove cotter pin
.
–
Remove pin
.
–
Take off retaining spring
and remove the brake linings.
–
Clean the brake caliper.
–
Position the new brake linings.
Info
Always change the full set of brake linings.
–
Position retaining spring
.
–
Mount bolt
.
Info
To make it easier to mount the pin, push the retainer spring down.
Make sure the retaining spring is seated correctly.
–
Mount cotter pin
.
B01697-10
–
Position the brake caliper. Mount screws
with the spacers but do not tighten
yet.
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point. Fix the hand brake lever in the acti-
vated position.
The brake caliper straightens.
–
Tighten screws
.
Guideline
Screw, front brake caliper
M8
25 Nm
(18.4 lbf ft)
Loctite
®
243™
