11
TUNING THE CHASSIS
37
11.14
Handlebar position
M01029-10
On the upper triple clamp, there are two holes at a distance of
to each other.
Hole distance
15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance of
from the center.
Hole distance
3.5 mm (0.138 in)
The handlebar supports can be mounted in four different positions.
11.15
Adjusting the handlebar position
Warning
Danger of accidents
Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
M01029-11
–
Remove screws
. Remove the handlebar clamps. Take off the handlebar and lay
it to one side.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
–
Remove screws
. Take off the handlebar supports.
–
Move the handlebar supports into the desired position. Mount and tighten
screws
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
and tighten evenly.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.
