2 SETUP
11
F01140-10
–
Position turn signal cable harness.
–
Insert the indicator lamp with the black and violet cable
colors into socket
6
.
F01139-10
–
Position turn signal on the headlight mask on both sides,
mount nuts with washers and tighten.
–
Connect the plug-in connector
7
of the left turn signal
using the violet and brown cable colors of the turn signal
cable harness.
–
Connect the plug-in connector
8
of the right turn signal
using the black and brown cable colors of the turn signal
cable harness.
Info
Pay attention to where the brake line is routed when
doing so.
–
Connect plug-in connector
9
of the headlight.
–
Connect plug-in connector
bk
of the turn signal switch.
–
Secure turn signal relay
bl
with a cable tie and plug in
the connector.
–
Install the headlight mask with the headlight. (
F01141-10
–
Pull the EFI control unit
bm
upward off the rubber
plugs
bn
and hang to the side.
–
Remove holding bracket
bo
and hang to the side.
F01142-10
–
Route the turn signal cable harness from the front to the
rear as far as the battery compartment.
–
Position and secure turn signal cable harness using cable
ties to the main wiring harness under the rubber bands of
fuel tank support.
