KTM 950 Adventure 2005, Owner'S Manual

Page: 36 / 62

ENGLISH
35
MAINTENANCE WORK ON CHASSIS AND ENGINE
»
Replacing the headlight lamps *
Remove the 5 screws on the left and right and take off both side covers [1] .
Use a screwdriver to detach the retaining tabs [2] , tilt the windshield and
headlight forward and pull the connector off the connector support. Place the
headlight on a soft pad to keep it from being damaged.
NEVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS. THE GLASS OF
THE BULB MUST REMAIN ABSOLUTELY FREE FROM GREASE. HEAT WILL OTHER-
WISE CAUSE THE GREASE TO EVAPORATE AND SETTLE DOWN ON THE
REFLECTOR.
HIGH BEAM BULB
[A]
:
Remove the rubber cap
[3]
and pull off the connector
[4]
. Detach the retain-
ing clip and remove the bulb.
Fit the retaining clip, connect the connector and mount the rubber cap.
LOW BEAM BULB [B] :
Remove the rubber cap [5] and pull off the connector [6] . Detach the retain-
ing clip and remove the bulb.
When inserting the new bulb, make sure tab [D] is firmly seated in the socket
recess.
Fit the retaining clip, connect the connector to the bulb and mount the
rubber cap.
PARKING LIGHT BULB [C] :
Pull the bulb socket [7] out of the reflector and pull the bulb out of the bulb
socket.
USA design:
The parking light [E] is located in the upper part of the headlight in the USA
design. Bulb [F] with high and low beams is mounted in the lower part of the
headlight.
Connect the connectors to the connector support to check all of the bulbs for
proper functioning before you remount the headlight.
E F
C
7
D
1
2
3
4
A
B
5 6