KTM 690 ENDURO AUS/UK 2008, Owner'S Manual

Page: 82 / 179

MAINTENANCE WORK ON CHASSIS AND ENGINE
80
100254-10
–
Remove screws

.
–
Remove cover

with membrane

.
–
Add brake fluid to level

.
Specification
Measurement of

5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( P. 166)
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Position the cover with the membrane. Mount and tighten screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
9.31
Brake linings
The brake linings fitted by KTM were tested over long periods and ensure optimal braking properties. The type names of brake pads are
entered in the homologation documents.
Info
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construction and
friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM brake linings. If
brake linings are used that differ from the originals, there is no guarantee that they comply with the original license. The vehicle
no longer corresponds to the condition at delivery, and the warranty is no longer valid.