KTM 690 Duke CN 2016, Setup Instructions

Page: 10 / 15

3 WORK
8
Note
Material damage Premature clogging of the fuel filter.
–
In some countries and regions, the available fuel quality and cleanliness may not be sufficient. This will result in problems with
the fuel system.
–
Only refuel with clean fuel that meets the specified standards.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
B00935-10
–
Switch off the engine.
–
Open the filler cap. ( p. 8)
–
Fill the fuel tank with fuel up to the lower edge

of the filler neck.
Total fuel tank
capacity, approx. 14 l (3.7 US gal) Super unleaded (ROZ 95/RON 95/PON
91) (
p. 12)
–
Close the filler cap. ( p. 9)
3.8 Opening the filler cap
Danger
Fire hazard
Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that has been contaminated with
fuel. Store fuel properly in a suitable canister and keep away from children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
M00657-10
–
Lift cover

of the filler cap and insert the ignition key in the lock.
Note
Danger of damage Ignition key breakage.
–
To take pressure off of the ignition key, push down on the filler cap. Damaged
ignition keys must be replaced.
–
Turn the ignition key 90° clockwise.
–
Open the filler cap.