MAINTENANCE WORK ON CHASSIS AND ENGINE
82
Warning
Danger of accidents
No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the footbrake until the pressure point is reached.
–
Check the rear hub rubber dampers.
x
(
p. 83)
100146-10
–
Remove the bushing
. Clean and grease the working surfaces of the bushing and shaft
seal ring
.
Long-life grease (
p. 167)
–
Clean and grease the thread of the wheel spindle and nut
.
Long-life grease (
p. 167)
–
Clean the fixing locations on the brake caliper support and swingarm.
–
Install the rubber damper and rear sprocket carrier in the rear wheel.
–
Stand the rear wheel in the swingarm and mount the brake caliper on the brake disc.
100147-10
–
Push the brake caliper support and the swingarm
into the fixing location. Lay the
chain on the rear sprocket and mount the wheel spindle.
Info
Mount the left and right chain adjusters
in the same position.
–
Push the rear wheel forward so that the chain adjusters are in contact with the adjust-
ing screws, and tighten nut
.
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
.
Nut, rear wheel spindle
M25x1.5
90 Nm
(66.4 lbf ft)
