KTM 690 Duke 2018, Setup Instructions

Page: 8 / 20

3 WORK
6
3.1 Removing the passenger seat
V00043-10
–
Insert the ignition key in seat lock
1
and turn it clockwise.
–
Raise the rear of the passenger seat, push it towards the rear,
and remove it upward.
–
Remove the ignition key from the seat lock.
3.2 Mounting the passenger seat
K00421-10
–
Hook catches 1 of the passenger seat onto the storage com-
partment, lower the rear, and simultaneously push forward.
–
Press down the passenger seat until it clicks into place.
Warning
Danger of accidents The passenger seat can come
loose from the anchoring if it is not mounted correctly.
–
After mounting the passenger seat, check that it is
locked correctly by pulling up.
–
Finally, check that the passenger seat is correctly mounted.
3.3 Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks or open flames away from the battery.
–
Only charge batteries in well-ventilated rooms.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.