KTM 64112950044, Fitting Instructions Manual

Page: 23 / 62

ENGLISH
ASSEMBLY 5
9
502645-01
–
Remove the cable tie.
–
Connect the plug of the USB charging socket
2
(included) to
ACC2.
Info
The USB charging socket may not be connected to
ACC1. There is a sticker labeled ACC1 and ACC2 on
the cables of the wiring harness.
If necessary, the connector protection must be shorte-
ned.
Info
On models where the connector bm for technical acces-
sories is present, the USB charging socket 2 (inclu-
ded) is plugged into it.
502644-01
–
Route connector and cables without tension and secure with
cable ties.
–
Position the cover, threading the headlight plug-in connector
and the USB charging socket with cable through the opening.
–
Hold the turn signal in area
A
and carefully press against the
direction of travel, while pressing the cover tight at the same
time.
The cover engages with an audible click.
–
Repeat the operation on the opposite side.
502646-01
–
Mount and tighten screws
bk
.
Guideline
Screw, cover M5 5 Nm (3.7 lbf ft)
–
Mount and tighten screws
9
.
Guideline
Screw, cover EJOT PT
K50x14
2 Nm (1.5 lbf ft)
–
Mount and tighten left screw
bl
.
Guideline
Screw, cover M5 5 Nm (3.7 lbf ft)