KTM 350 SX-F EU 2011, Setup Instructions

Page: 7 / 15

SET
‑
UP
5
101018-01
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. ( p. 6)
–
Install the front wheel. ( p. 6)
–
Correctly mount the fuel tank breather.
B00539-01
–
Secure the handlebar cushion with two cable binders.
–
Install the start number plate. ( p. 6)
101019-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Plier for footrest spring (58429083000)
800035-10
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ven-
tilated rooms.
–
Flush with copious amounts of water in case of skin contact. If battery
acid comes into contact with the eyes, flush the eyes with water for at
least 15 minutes and consult a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Charge the battery. ( p. 7)
–
Install the battery. ( p. 7)
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying KTM PowerParts installation instructions.
–
Apply the label included in the delivery (optional).
–
Refuel. ( p. 9)
–
Position all controls exactly on the handlebar. Tighten all screws.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.