KTM 350 EXC-F AUS 2014, Setup Instructions

Page: 6 / 24

2 SETUP
4
(All SIXDAYS models)
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp M8 17 Nm
(12.5 lbf ft)
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)
Info
The rebound damping is located in the right fork leg REB (red
adjusting screw). The compression damping is located in the left
fork leg
COMP
(white adjusting screw).
Grooves are milled into the side of the top end of the fork legs. The
topmost milled groove must be flush with the top edge of the upper
triple clamp.
Position the bleeder screws toward the front.
101488-10
–
Remove screws
1
. Take off the handlebar clamps.
–
Remove screws
2
. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws
2
.
Guideline
Screw, handlebar holder M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
C00108-10
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
C00521-01
(EXC
‑
F EU, EXC
‑
F AUS, EXC-F USA)
–
Insert the indicator lamp with the black and black cable colors into
socket
3
.
–
Insert the indicator lamp with the black and violet cable colors into
socket
4
.
–
Insert the indicator lamp with the orange and brown cable colors into
socket
5
.
–
Insert indicator lamp LED with the black and black cable colors into
socket
6
.