MAINTENANCE WORK ON CHASSIS AND ENGINE
46
600063-10
–
Position brake linings
and insert bolts
by hand.
–
Position brake caliper, mount and tighten screws
.
Guideline
Screw, front brake caliper
M8
30 Nm
(22.1 lbf ft)
Loctite
®
243™
–
Mount the bolt
with a suitable tool and insert the lock pin
.
–
Operate the hand brake lever repeatedly until the brake linings lie on the brake disc
and there is a tight spot.
8.43
Changing the front brake linings
x
Warning
Skin irritations
Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents
Reduced braking due to old brake fluid.
–
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazard
Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
600058-10
–
Remove the front brake linings.
x
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
.
–
Remove cover
with membrane
.
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
–
Install the front brake linings.
600059-10
–
Add brake fluid to level
.
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
Summary of Contents for 2009 690 Rally Factory Replica
Page 1: ...OWNER S MANUAL 2009 690 Rally Factory Replica ART NO 3211361en...
Page 2: ......
Page 87: ...85...
Page 91: ...WIRING DIAGRAM 89...