0
0
B
B
0
0
B
B
0
0
A
A
0
0
A
A
MAINTENANCE WORK ON CHASSIS AND ENGINE
54
13.40
Refitting the headlight mask with the headlight (EXC
‑
F, EXC
‑
F SIX DAYS, XCF-W ZA)
600702-11
–
Connect the electric plug connector
.
600703-11
–
Position the headlight mask and fix it with the rubber band
.
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and cable harness. Put the clamp on, mount and tighten
screw
.
–
Check the headlamp setting.
13.41
Dismount the start number plate (XCF
‑
W USA, XC
‑
F, SX
‑
F)
500101-10
–
Remove screw
and take off clamp.
–
Remove screw
with the spacing sleeve. Remove the start number plate.
13.42
Installing the start number plate (XCF
‑
W USA, XC
‑
F, SX
‑
F)
500101-11
–
Position the start number plate. Mount and tighten screw
with the spacing
sleeve.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and cable harness. Put the clamp on, mount and tighten
screw
.
13.43
Handlebar position
400223-11
On the upper triple clamp, there are 2 holes at a distance of
to each other.
Distance
between holes
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of
from the center.
Distance
between holes
3.5 mm (0.138 in)
The handlebar supports can be mounted in 4 different positions.
(250 EXC-F SIX DAYS EU)
The handlebar supports can also be mounted at 2 different heights (with and with-
out spacer).
Thick spacer
9 mm (0.35 in)
Summary of Contents for 2009 250 EXC-F SIX DAYS
Page 2: ......
Page 110: ...WIRING DIAGRAM 108 ye re Yellow red ...
Page 111: ...WIRING DIAGRAM 109 ...