KTM 1290 Super Adventure T 2017, Setup Instructions

Page: 20 / 26

3 WORK
18
3.19 Adjusting the headlight range
Preparatory work
–
Check the setting of the lighting system. ( p. 16)
–
Remove the bottom triple clamp cover. ( p. 9)
M00807-10
Main work
–
Turn adjusting screw
1
to adjust the headlight range.
Info
Turn clockwise to increase the headlight range; turn counterclockwise to
reduce the headlight range.
If you have a payload, you may have to correct the headlight range.
402424-10
–
Set the headlight to marking
A
.
Guideline
The light-dark boundary must lie exactly on the lower mark
A
when the motor-
cycle is ready to operate with the rider mounted along with any luggage and a
passenger if applicable.
Finishing work
–
Install the bottom triple clamp cover. ( p. 10)
3.20 Adjusting the cornering light range
Preparatory work
–
Check the setting of the lighting system. ( p. 16)
Main work
–
Press the UP or DOWN button until the "Settings" menu appears on the matrix dis-
play. Pressing the SET button opens the menu.
–
Press the UP or DOWN button until "cLightTest" is highlighted in black on the matrix
display. Pressing the SET button again starts the cornering light test.
–
Wait for a few seconds until the upper segment of the left cornering light lights up
continuously.
S01612-10
–
Turn adjusting screw
1
to adjust the left cornering light range.
Info
Turn clockwise to increase the headlight range; turn counterclockwise to
reduce the headlight range.
402427-01
–
Set the upper segment on the left marking.
Guideline
The light-dark boundary of the upper segment must run exactly through the left
marking.
–
Press the SET button.
The left cornering light is switched off.
The right cornering light test is started.
–
Wait for a few seconds until the upper segment of the right cornering light lights up
continuously.