KTM 1290 Super Adventure T 2017, Setup Instructions

Page: 19 / 26

3 WORK
17
0 0 A A
0 0 B B 0 0 B B
402426-10
–
Make two further marks spaced apart
B
to the left and the right of the second
marking.
Guideline
Distance B
71.5 cm (28.15 in)
402425-10
–
Position the vehicle perpendicular to the wall at a distance
C
from the wall and
switch on the low beam.
Guideline
Distance C
5 m (16 ft)
–
The rider, with luggage and passenger if applicable, now mounts the motorcycle.
–
Check the headlight setting.
The light-dark boundary of the low beam must lie exactly on the lower mark when
the motorcycle is ready to operate with the rider mounted along with any luggage
and a passenger if applicable.
» If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. ( p. 18)
–
Press the UP or DOWN button until the "Settings" menu appears on the matrix dis-
play. Pressing the
SET
button opens the menu.
–
Press the
UP
or
DOWN
button until
"cLightTest"
is highlighted in black on the matrix
display. Pressing the SET button again starts the cornering light test.
–
Wait for a few seconds until the upper segment of the left cornering light lights up
continuously.
402427-01
–
Checking the left cornering light setting.
The light-dark boundary of the upper segment must run exactly through the left
marking.
» If the boundary between light and dark does not meet specifications:
–
Adjust the cornering light range. ( p. 18)
–
Press the SET button.
The left cornering light is switched off.
The right cornering light test is started.
–
Wait for a few seconds until the upper segment of the right cornering light lights up
continuously.
402428-01
–
Checking the right cornering light setting.
The light-dark boundary of the upper segment must run exactly through the right
marking.
» If the boundary between light and dark does not meet specifications:
–
Adjust the cornering light range. ( p. 18)
–
Press the SET button.
The cornering light is switched off.