EN
G
L
IS
H
5
1
2
1
8
X
3
A
Scope of supply:
Fork protector reinforcement
78001993000
2x collar screws M6x15
2x bushings
2x reinforcement plates
2x countersunk screws M5x10
Factory start
SXS12540100
1x snap ring
2x allen head screws M3x10
1x snap button
4x countersunk screws M5x5
Assembly
-
Jack up the motorcycle.
-
Remove the front wheel (see the Owner’s Manual).
-
Remove the right fork leg (in the direction of travel) and the fork pro-
tector
(2)
.
-
Place the snap ring
(1)
onto the fork leg, slide it all the way down and
screw it on. The snap area must face forward.
-
Mounting the snap button on the fork protector
-
Measure a length "X", see table, down from the upper edge and
drill a 13.5 mm hole that is centered on that position. For the late-
ral positioning, measure 18 mm to the left from the shadow edge
on the front.
-
Position the snap button into the hole from the outside and mark
the four smaller drill holes with a marker
(A)
.
-
Drill 5 mm holes at the marks.
-
Countersink the 5 mm holes from the inside either manually using
a 10 mm drill bit
(3)
or using a countersink to the point where the
heads of the M5x5 countersunk screws are roughly level with the
fork protector.
-
Position the snap button on the fork protector, secure the M5x5
countersunk screws with Loctite 243, and tighten them with 3.5
Nm from the inside.
Model
"X"
USD 48
95 ± 10 mm
USD 48 SMR
90 ± 10 mm
-
Mounting the reinforcement plates
-
Position the two reinforcement plates on the outside of the fork
protector as shown and mark the drill holes with a marker.
