ENGLISH
4
Preparations
- Cut off the ends of the left and right rubber grips (approx. 3 mm from the
edge) with a sharp knife.
- Push back the rubber grip on the throttle twist grip somewhat.
- Release the screws
(4)
and slide the throttle twist grip outward by approx.
20 mm.
- Saw off the end of the throttle twist grip (approx. 3 mm from the edge)
(Figure
A
).
Do not damage the handlebar when sawing.
- Deburr the edges of the throttle twist grip if necessary.
Scope of supply:
2x hand guards
(1)
black
7650207905030
orange
7650207905004
2x aluminum brackets
(2)
76502979044
These hand guards do not provide protection against injury.
Assembly
NOTE:
The assembly steps apply to both the left and right sides. Do not overtighten
screws.
- Insert screw
(5)
through the drilled hole in the aluminum bracket and mount
with the insert
(6)
(Figure
B
).
NOTE:
Let the screw engage only slightly.
- Mount the aluminum bracket with the inserts into the handlebar end and
initially tighten hand-tight only (Figure
B
).
- Release screws
(7)
and
(8)
and mount the handlebar clamps
(9)
on the
handlebar.
NOTE:
Choose the clamp connection part
(9b)
with offset to the left or right depen-
ding on what is needed to connect the backbone to clamp
(9a)
.
- Position the aluminum bracket
(10)
and mount the screw
(11)
, initially
tightening hand-tight only.
- Properly mount the throttle twist grip (for Nm, see the Owner's Manual).
- Mount the hand protector
(1)
on the aluminum bracket
(10)
.
- Tighten all screws in the following order:
NOTE:
Before tightening the screws, move the hand guard into its final position.
- Tighten the screw
(11)
.
- Tighten the screw
(8)
.
- Tighten the screw
(7)
.
- Tighten the remaining screws.
Check the screw connections again and ensure that all control elements, espe-
cially the coupling, brake and throttle, are functioning properly.
Smooth operation and correct functioning of the controls need to be che-
cked regularly.
1
1
2
4
4
A
B
5
6
7
11
10
8
9a
9b
