KVB-311 Broadband VoIP Router User Manual
2.1.4 Essential Configuration via Telnet Command Line interface
This section describes how to setup the gateway via Telnet command line interface.
Please follow procedures below to configure essential items.
2.1.4.1 Save Data and Reboot
After any configuration has been made, user has to save all data and reboot system to
make configurations take effect.
Step 1.
Confirm the changed configurations, input [commit] and press [enter] key to
save it.
Step 2.
Input [reboot] then press [enter] key to restart Gateway.
Step 3.
After around 40 seconds, Gateway will take effect in new configurations.
Do not turn off your Gateway or remove the Gateway while saving your
configuration.
2.1.4.2 Setup Network
Use command [ifaddr] to configure Gateway IP Address and related information.
(1) Fixed IP
usr/config$ ifaddr –ip 192.168.1.11 –mask 255.2555.255.0 –gate 192.168.1.254
In this case is to configure Gateway IP Address as [192.168.1.11], subnet mask
as [255.255.255.0], default router gateway as [192.168.1.254].
(2) DHCP
usr/config$ ifaddr –dhcp 1
In this case is to enable DHCP mode of the gateway, once the gateway reboot the
system, it will automatically capture IP from DHCP server.
(3) PPPoE
Step 1.
To Set PPPoE mode, please use [pppoe] command:
usr/config$ pppoe –dve 1 (PPPoE used)
usr/config$ pppoe –open (PPPoE open)
Step 2.
Input the user id & password provided by your ISP:
usr/config$ pppoe –id [email protected] (PPPoE login account)
usr/config$ pppoe –pwd 123 (PPPoE login Passowd)
For example:
- 18 -