KVB-311 Broadband VoIP Router User Manual
CAT-5 straight Ethernet cable.
Step 2. Connect your PC to the LAN port of the gateway
Connect your PC to the LAN port of the gateway with standard CAT-5
straight Ethernet cable.
Step 3. Set your PC as DHCP mode
Please go to the network setting of your PC and set it as DHCP mode, let
your PC can automatically search for DHCP server and get one valid IP
address. The gateway has embedded DHCP server (default is enabled)
so that your PC will get one IP address from gateway DHCP server.
Step 4.Open your browser and input IP address 192.168.123.123
Once your PC has got an IP from the gateway, you may connect to the
gateway via WEB browser to do more configurations. The default LAN IP
address is “
192.168.123.123
”; type this IP address on web browser
address bar and click “enter” to connect with web management interface.
Refer to Part III Web management for more information.
Step 5.Advanced Setting via Telnet (Optional)
If user wants to do more advanced and complete settings that cannot be
found via web management interface, please Telnet to the gateway to do
more detail configurations.
Step 6.Connect other PC with LAN Ports (Optional)
If you have more than one PC, you can connect them with LAN Ports
(black) on the Gateway. Configure these PCs as DHCP mode so that
they can automatically get IP from gateway DHCP server. DHCP server
can assign 253 IP addresses at most.
Caution:
To prevent damage to the Gateway, please make sure you have
connected with the supplied power adapter.
2.1.3 Essential Configuration via Web Management interface
This section describes how to setup the KVT-311 gateway via Web management
interface. Follow procedures below to configure essential parameters before you use
the gateway.
2.1.3.1 Save Data and Reboot
After any configuration has been made, user has to save all data and reboot system to
make configurations take effect.
- 9 -
