-23-
2.13 Configuring IP Address and Password for the Switch
The switch is shipped with the following factory default settings for software management :
Default
IP address of the switch :
192.168.0.2 / 255.255.255.0
The IP Address is an identification of the switch in a TCP/IP network. Each switch should be desig-
nated a new and unique IP address in the network. Two methods to configure the IP address are:
1. Use console port
The console command sequence to set a fixed IP for the switch is:
>IP
↵
IP>Setup [<ipaddress>[<ipmask>[<ipgateway>]]]
↵
The console command sequence to use DHCP mode for IP is:
>IP
↵
IP>Dhcp enable
↵
IP>
2. Use Web management
Refer to Web management interface for System Configuration. The switch is shipped with
factory default password
123
for software management. The password is used for authentication
in accessing to the switch via Http web-based interface. For security reason, it is recommended to
change the default settings for the switch before deploying it to your network. Refer to Web
management interface for System Configuration.
