1.
<<Operations in the Measurement Mode>>
(2) (continued)
After a measurement is
made, the torque reading
is shown on the display.
The display shows the
maximum measurement
when the Peak Hold
mode is active.
To disable the Peak Hold
mode, press the + (Plus)/
(Clear) button.
NOTE
The display keeps showing the torque while no operation is made.
If no operation is made for two minutes, however, the power is
automatically turned off and thus the measured torque is lost.
2.
<<Unit Conversion >>
NOTE
NOTE
NOTE
The value after conversion is a
reference value. In addition, since
values after conversion have been
rounded according to the
minimum display unit, the values
are a little off the original value.
The unit indicator will light after
the unit conversion is made to
signal that the value is just a
reference value.
Be aware that pressing the P button
for a long time will turn OFF the power.
After a measurement is made in a mode
with the Peak Hold function active or while
a torque is being set in the Preset mode,
you can convert the torque into a value in
another unit by pressing the P button.
P button
The
Digital Ratchet
has the function to convert units for measurements.
No unit conversion can be made in
the Track mode.