1 - Detection Area
Detection area can be reduced by selecting
the combination on the Dip Switches,
following the guide as shown here.
2 - Hold Time
Hold time means the time period you would
like the light to remiain 'on' once no movement
is detected.
3 - Daylight Sensor
The daylight sensor can be set to bring the
light 'on' at specific daylight levels. To have
the sensor function in daylight set the Dip
Switches to Disable.
KSR Lighting Ltd, Unit E Hazleton Interchange, Lakesmere Road, Horndean, Hampshire, PO8 9JU
Installation Sheet
KSRSF332
Read these instructions before commencing installation. Please give these instructions to the
owner/occupier after installation to retain for future reference/maintainence.
KSR Microwave On/Off Sensor Set Up Guide
Issue
Cause
Solution
The load will
not illuminate
Incorrect daylight threshold
setting selected
Adjust setting and
retest
Load has failed
(driver or LED array)
Replace load
No mains power detected
Switch on power
The load is
permanently
illuminated
Continuous movement in
the detection area
The lamp (containing sensor)
is installed in an area too close
to reflective surface, i.e Metal,
Glass or Concrete walls.
Check detection area setting
Make sure installation area suitable
with at least 30cm space
between lamp and surrounding
reflective surfaces
Reduce Sensitivity (detection area)
1.
2.
The load will not
illuminate despite
movement
Speed of moving object is not
in the range of 0.5-3m/s or the
detection radius is too small
Check Detection area setting
This Microwave sensor is a motion activated switch, it will turn the light on when
movement is detected, then hold the light on for the determined amount of
time, after which the light will turn off.
Using the Dip Switches on the sensor, set it up to your preferred Detection area,
Hold Time & Daylight level.
Microwave sensors will detect movement through certain materials, if this occurs
reduce the detection area until any nuisance triggering stops.
Max Load - 400W (Inductive)(LEDs)
Max Load - 800W (Resistive)
Troubleshooting
The Sensor is designed for installation heights of 3-6m
Recommended Installation heights
For Wall mounting the height is 1.5m
For Ceiling mounting the height is 3m
Detection Zone Max. (D x H): 12m x 6m
Detection Angle: 150° (wall Installation)
360° (ceiling Installation)
Navara SF Select
6m
2-6m
6m
Diameter (D)
Height (H)