KSM-Stoker KSM-Multistoker 175-13, Instructions Manual, Page: 25 / 69

- 22 -
6.34 Start portion.
When the boiler has been in the pause mode and is about to start up again, we add an adequate portion of
fuel (”START FUEL”) to enable the starting-up and facilitate for the oxygen % to quickly drop below the
“START-UP OXYGEN LIMIT” before the end of the “START-UP PERIOD”.
In case the boiler stops because the oxygen % is still too high, after the ”START-UP PERIOD” has
expired, you have to either enlarge the “START PORTION” or prolong the “START-UP PERIOD”.
If the boiler is fitted with an automatic ignition, the ”START FUEL” must be so large that the fuel will
reach nearly up to the ignition nozzle; if not, you will have the same problem with the “START-UP
OXYGEN LIMIT”.
START FUEL
Press ”MENU”
START FUEL
AFTERRUN ADJUST 1.60 SEC
Use the arrow keys to set the screw running period for the start portion, select a value from 0.03 and up to
52sec.
After selection of the wanted start portion press ”MENU”, and your choice has been saved.
Press ”
▼
” to proceed to the next parameter you wish to change – or press the ”START-UP” and the
“MENU” keys at the same time to finish.
6.35 Afterrun.
Not in use in this standard control.
AFTERRUN
START FUEL 2-3
Therefore -
Press ”
▼
” to proceed to the next parameter you wish to change – or press the ”START-UP” and the
“MENU” keys at the same time to finish.
6.36 Start portion 2-3.
When the boiler are going from step 2 to 3, we add an adequate portion of fuel (”START FUEL 2-3”) to
enable full out-put as soon as possible.
If the boiler get to little fuel at this time, the temperature will drop to much, before it start raisung again.
If it gets to much, you will get black smoke from the chimney.
START FUEL 2-3
Press ”MENU”
START FUEL 2-3
BOILERTEMP START. ADJUST 1.60 SEC
Use the arrow keys to set the screw running period for the start portion, select a value from 0.03 and up to
52sec.
After selection of the wanted start portion press ”MENU”, and your choice has been saved.