code R30019.101en www.kseniasecurity.com
ed.04/2020
•
Connect the power supply poles + and - (12Vcc) to their clamps (n.14) and the acid lead backup battery
to the respective cables with faston (n.21) after been placed on its base (n.10) as shown in next figure
If wiring is correct, imago will show a single flash by the power LED and a short BEEP by the buzzer.
ENROLLING
To enrol imago wireless on the system, please follow the procedure here below:
1. On the ergo keypad, browse the programming menu till the ‘Enroll’ mode
2. Move the front anti-opening switch (open/close the cover of the imago)
3. On the ergo keypad, confirm the S.N. of the device.
If enrolling is successfully made, the red LED on RF PCB module will turns on as confirmation.
For any additional information, please see the lares 4.0 Programming Manual.
QUANTITY DATA
FUNCTIONS
The device programming and the panel configuration are made by basis SW.
The siren manages the outputs as:
•
If imago is powered with the non-rechargeable battery (KSI7207580.000) the outputs will be managed
as below, regardless the programmed configuration:
• Alarm output: monostable with the same ON time as programmed on the Panel (default: 3 min.)
• Power LED output: monostable with fixed 20 sec. ON time
• Aux LED output: monostable with fixed 20 sec. ON time; this function is designed to save battery
•
If imago wireless is powered with external 12Vdc supply and rechargeable acid lead battery, it will
manage the outputs as programmed.
During the programming phase, every time the imago sends a tamper signal to the panel and it is
acknowledged the red LED on the wireless PCN module will blink.
lares 4.0 models
wls 96
16
40
40 wls
140 wls
644 wls
Maximum number of imago
wireless siren
3
3
3
3
5
5
