code R30019.101en www.kseniasecurity.com
ed.04/2020
INSTALLATION
The imago wireless should be installed in a place hardly accessible to discourage any attempts of tampering;
of course sooner or later having to be reached if non-rechargeable battery replacement (if it is powered with
the latter), it must still be accessible for later intervention. The wall bracket must not show depressions and/
or bosses in order not to compromise the operation of tamper mechanism.
For a correct installation, please refer to the ‘Parts identification‘ paragraph and follow the steps here
below:
1. Insert the stainless steel hinges (included) and close the nuts (please not tight)
2. Open the polycarbonate cover using a plate screwdriver near the corners.
3. Remove the metallic undercover, paying attention to not damage the PCBA
4. Using a drill, bore the base fixing holes (the central one is already made to make the installation easier)
5. If you wants to power up the device with direct 12Vdc supply, pass the cables through the eyelet
6. Fix the polycarbonate base with Fishers plug (included)
7. If you chose to use external supply:
A - Link the power supply cable to the clamps following the correct polarity
B - Place and link the 6Vdc - 1.2Ah acid lead battery
• Place and link the non-rechargeable battery pack KSI7207580.000
8. Verify the correct power up
9. Re-insert the undercover starting from the top and paying attention to not damage the PCBA
10. Close the cover
Note
: All fixing devices required for the proper installation are included in the package.
TAMPERS
The imago wireless siren has two protections: against opening the device and against forced removal from
the wall on which was fixed (two switches in series). The siren constantly checks the status of these two
switches and their eventual opening will be communicated to the lares 4.0. Then, subject to programming,
lares 4.0 may requires the activation of acoustic and luminous signals to report the attempted sabotage.
POWERING UP
The procedure to power up the imago requires to respect at least one of the following steps (refer to figure
in “Description of the product” paragraph):
•
Connect the batteries to their connector (n.13) and place it on its base (n.10) as shown in next figure
OR
