EN
37
JAMMING DETECTION
ENROLL, REMOVE OR CHANGE A WIRELESS DETECTOR
This parameter allows to enable/disable the Jamming detection. If enabled, the
device will generates an alarm moving the output associated with
O6
terminal
when detects a jamming over -70dbM.
• If this parameter is OFF,
O6
output will signal only sabotage
• If this parameter is ON,
O6
output will signal both sabotage and jamming
By default, this parameter is OFF. To set it ON, please proceed as follow:
To modify the system status, please proceed as follow:
• from
Options
, press ENTER and use the circular scroll to go to Jamming.
Press ENTER to confirm.
• select ON or OFF using the circular scroll
• press ENTER to confirm. By pressing ESC you abort the operation
• After confirm, the menu comes back to the ‘Jamming’ point. Press ESC to
return to
Options
menu
In this paragraph, the procedures to manage the different kind of wireless sensors
compatibles with
universal duo
are described. Once in programming menù, use
the circular scroll to go to:
By pressing ENTER you will access to the
Wireless
Detectors
sub-menù, on which these functions are
available:
Enroll
Allows to enroll a new detector in the system. LThe enrolling take place by
saving the serial number (
SN
) of the device, configuring its specific features and
associating it with a group, then to a specific output. To make it easier, it is possible
to use a table like the one shown in the next page and take note of essential
informations.
IMPORTANT: the wireless detectors you want to enroll have to be covered by the
RF range of system.
Programming
Wireless Detector
