3 Transport/Temporary Storage/Disposal
12 of 44
UPAchrom
CAUTION
Ambient temperature below the specified minimum
Danger of frost!
▷
Never subject the pump set to ambient temperatures which are lower than
those permitted for the drinking water/antifreeze mixture provided (see section
on drinking water/antifreeze mixture / order documentation).
CAUTION
Improper storage
Damage to the power cables!
▷
Support the power cables at the cable entries to prevent permanent
deformation. Observe the minimum bending radius
2)
of the cables.
▷
Only remove the protective caps from the power cables at the time of
installation.
For temporary storage, store the submersible borehole pumps as follows:
1.
In the original packaging: in a
horizontal
position
2.
Without packaging: in a
vertical
position (with the motor below)
3.
In a dry environment
4.
Protected against direct sunlight and heat
5.
Protected against dirt and dust
6.
Protected against freezing
7.
Protected against vermin
3.4 Return to supplier
1.
Drain the pump as per operating instructions.
2.
Always flush and clean the pump, particularly if it has been used for handling
noxious, explosive, hot or other hazardous fluids.
3.
If the pump set has handled fluids whose residues could lead to corrosion
damage in the presence of atmospheric humidity or could ignite upon contact
with oxygen, the pump set must also be neutralised, and anhydrous inert gas
must be blown through the pump to ensure drying.
4.
Always complete and enclose a certificate of decontamination when returning
the pump (set).
Always indicate any safety and decontamination measures taken.
NOTE
If required, a blank certificate of decontamination can be downloaded from the
following web site:
www.ksb.com/certificate_of_decontamination
2)
See cable manufacturer's documentation or DIN VDE 0298-3.
