KSB moviBOOST VP, Operating Instructions Manual

Page: 26 / 30

moviBOOST VP
Acceptance report
The KSB pressure boosting unit specified below was today commissioned by the undersigned, authorised KSB customer
service engineer who created this report.
1 Pressure Boosting Unit
Type series moviBOOST ____________________
Size ______________________________
Works number ______________________________
Order No. ______________________________
2 Purchaser / Place of Installation
Purchaser Place of Installation
Name _________________________________ ________________________________________________
Address _________________________________ ________________________________________________
_________________________________ ________________________________________________
3 Operating Data
For further details please refer to the circuit diagram.
Start pressure p
E
bar ______________ Inlet pressure monitoring p
vor-x
= _____________________
(Value set at inlet pressure switch)
Stop pressure p
A
bar ______________
Inlet pressure p
vor
bar ______________
Pre-charge pressure of
accumulator pvor bar ______________
4 Special information
The system operator must notify the responsible water company of commissioning.
If, in addition, the system is operated with pressure vessels of groups III/IV to the Pressure Vessel Directive, commissioning
shall comply with local regulations.
The system operator / operator’s representative herewith confirms to have received instructions on how to operate and
service the system. The relevant circuit diagrams and operating instructions have been handed over.
Defects found during commissioning Date of remedy
Defect 1
Name of KSB representative Name of purchaser
or representative
___________________________________________ ________________________________________________
Place Date
___________________________________________ ________________________________________________
24