7 Operation
41 of 92
KSB Delta Macro
1983.843/04-EN
1
2
3
4
5
6
Fig. 18:
Operating status of pump set P2
Table 18:
Pump operating status symbols
Position
Refers to
Description
1
Pump set in the system
Symbols for a specific pump set (in this example pump set 2)
2
Active messages
One or more warning messages or alert messages are active for pump
set 2.
3
Pump set running
Indicates whether the pump set is currently running. This symbol is
extinguishes when the pump set has been stopped or is in idle state.
4
Automatic mode
The pump set is started up and stopped via the control unit (F system) or
via a frequency inverter (VC and SVP systems).
5
Manual OFF
Pump start-up is locked. If a pump set is running, it will be stopped.
6
Manual ON
The pump set is started up manually.
In the case of an F system, the pump is started up. In the case of a VC or
SVP system, the pump starts running at a fixed frequency (fixed speed).
The fixed frequency can be configured.
7.2.5 Information on the system
1
2
3
4
5
6
7
Fig. 19:
Information on the system
Table 19:
Symbols for information on the system
Position
Refers to
Description
1
Display for suction-side
sensors
Depending on the connected sensors the following values are displayed:
▪
Version with pressure gauge:
Displays the pressure at the inlet of the
pressure booster system.
▪
Version with pressure switch / float switch / flow monitor:
Displays
the digital input signal Hi or Lo.
If several sensors are used, the values are displayed alternately.
▪
PIN display
– For connecting the control unit to the mobile device. (The
complete PIN is composed of this PIN and the PIN in position 7.)
▪
Display of the firmware version (The total firmware version is
composed of the numbers in this position and in position 7.)
2
Suction-side sensor
The corresponding values are shown in position 1.
The corresponding messages are shown in position 7.
