KSB 4EYS, Installation & Operating Manual

Page: 7 / 28

2 Safety
7 of 28
4EYS / 4EYT
1974.91/01-EN
2.8 Safety information for maintenance, inspection and installation
▪ Modifications or alterations of the mechanical seal require the manufacturer's
prior consent.
▪ Use only original spare parts or parts/components authorised by the
manufacturer. The use of other parts/components can invalidate any liability of
the manufacturer for resulting damage.
▪ The operator ensures that maintenance, inspection and installation are
performed by authorised, qualified specialist personnel who are thoroughly
familiar with the manual.
▪ Only carry out work on the mechanical seal when the shaft is not rotating.
For mechanical seals installed in pump sets:
▪ The pump (set) must have cooled down to ambient temperature.
▪ Pump pressure must have been released and the pump must have been drained.
▪
When taking the pump set out of service always adhere to the procedure
described in the manual.
▪ Decontaminate pumps which handle fluids posing a health hazard.
▪
As soon as the work has been completed, re-install and re-activate any safety-
relevant devices and protective devices. Before returning the product to service,
observe all instructions on commissioning.
▪ Observe the relevant sections of the corresponding pump operating manual.
2.9 Unauthorised modes of operation
Never operate the mechanical seal outside the limits stated in the data sheet and in
this operating manual.
The warranty relating to the operating reliability and safety of the mechanical seal
supplied is only valid if the mechanical seal is used in accordance with its intended
use.
Any damage caused by dry running shall be excluded from the warranty.