11
10
bATTERY REPlAcEMENT
bATTERY REPlAcEMENT
low BatterY IndIcator
the product has an advanced battery level management system consisting of 2 steps.
In the first step, the battery still has enough power to open and close the solenoid valve
and allows the solenoid valve to open.
In the second step the battery might not have enough power to open and close the
solenoid valve. In this case, the battery level management system does not allow the
solenoid valve to open. Instead of providing an opening and closing pulse, the systems
provides two closing pulses.
BatterY rePlacement InstructIons
6
Place the cap back into place and
tighten the allen screw.
note: make sure the o-rings are
still in thier groove.
- do not allow moisture or water into the system while the battery is being replaced.
- the interior of the faucet must be fully dry before reassembling the parts. If it is not fully
dry, carefully dry it.
ImPortant: spent batteries should not be disposed of with normal
household waste. contact your local authority for information on waste
disposal and recycling.
1
unscrew the m4x6 allen screw on
the faucet left hand side and pull
out the cap.
2
remove the battery cover protec-
tion and disconnect the connec-
tor between the battery and the
electronic unit.
3
take out the old battery.
4
replace the used battery with a
new 9V battery (a lithium battery
is recommended), and connect the
connector between the battery and
the electronic unit.
5
Put the battery protection cover
back on.
old BatterY
coVer
coVer
new BatterY
new BatterY
fIlter cleanIng InstructIons
the system is provided with two stainless steel filters preventing foreign particles to enter
the lines. It is recommended to clean the filters every six (6) months. If the water flow has
decreased, this may be because the filters are clogged. the filters can be cleaned as follows:
1. shut-off the water shut off valve.
2. disassemble the faucet and remove the filters located between the faucet nuts and the
eccentric unions
3. wash the filters under running water.
4. reassemble the parts.
5. make sure that there is no water leakage.
care and cleanIng of cHrome and sPecIal fInIsHes
do not use steel wool or cleansing agents containing alcohol, acid, abrasives, or the like.
use of any prohibited cleaning or maintenance products or substances could damage
the surface of the shower. for surface cleaning of shower use onlY soap and water, then
wipe dry with clean cloth or towel. when cleaning bathroom tile, the showers should be
protected from any splattering of harsh cleansers
MAINTENANcE