5
4
PRE-INsTAllATIoN INfo
check contents
separate all parts from the packaging and check each part with the “Pack
contents” section.
Pay attention to the different models variations.
make sure all parts are accounted for before discarding any packaging material.
If any parts are missing, do not attempt to install your electronic faucet until you
obtain the missing parts.
Warnings
do not install facing a mirror or any other electronic system operated by an
infrared
sensor.
to prevent reflection problems, it is recommended to keep a minimum distance
of 1.50 meters between the faucet and any other objects.
Preparation for installation
flush water supply lines thoroughly before installing the faucet. do not allow dirt,
teflon tape or metal particles to enter the faucet.
shut off water supply.
Important
all plumbing is to be installed in accordance with applicable codes and
regulations.
fAucET INsTAllATIoN
sTEP 1 – INsTAllING THE fAucET
1
shut off the water supply.
NoTE:
the standard distance between the water supply pipes centers is 150 mm.
two eccentric unions are provided to allow variations from 130mm to 170mm.
2
mount the eccentric unions on the water
supply pipes using the teflon thread
sealing tape.
3
apply the covering rosettes on the
eccentric unions, and set the eccentric
unions so that they correspond with the
faucet inlets.
IMPoRTANT:
to make sure it will be installed in the right location, the filter is joined to
the faucet nuts with a clear adhesive tape.
4
for THERMA II
: attach the cover to
the side of the body of the faucet and
connect internal wiring. Pass the power
supply wire through the premade hole
in the wall, leaving no excess on faucet
side. mount faucet and tighted cover to
conceal wire hole.
electricity wire
5
remove the clear adhesive tape holding
the filters in place.