9
8
FILLING THE SOAP TANK
1
Unscrew the soap tank from the pump assembly
and pull it out from the bottle support.
2
Fill the bottle with liquid soap to the top line.
Make sure the bottle is clean before filling it with
soap.
3
Insert the bottle back into the bottle support.
4
Screw the soap tank back into the pump
assembly. Make sure the tank is firmly secured
into place.
5
Press and hold the refill button located at the back
of the pump assembly until soap is dispensed
from the soap dispenser spout.
Release the button once soap begins dispensing
from the spout.
Alternately, use the FILL function on the remote
control (if available). see page 13/14.
Note: When the soap in the soap tank reaches the
bottom line, the tank needs to be refilled.
To refill the soap tank please refer to steps 1-5.
INSTALLATION
8
Insert the MF soap dispensers’ pipes to
the holes in the soap tank cap. Ensure the
soap pipe reaches the bottom of the soap
tank and is not bent or curved.
!
NOTE: The Top filling Multifeed Kit
enables installing up to 6 soap dispensers
simultaneously. When installing less than
6 soap dispensers, make sure to plug the
remaining holes with the provided plugs.
STEP 3 – CONNECTING THE POWER SOURCE
1
Connect the matching 4 contact connector
extending from the soap dispenser body
to the pump connector.
For FOAM version,
connect the matching
connector from the foam dispenser
body to the compressor unit, and the
compressor unit to the pump connector.
Please note that since the connector is
water proof, some pressure must be
applied for a prefect seal.
O-RING VISIBLE –
NOT CONNECTED PROPERLY
ONLY THE GROOVES ARE VISIBLE –
CONNECTED PROPERLY
IMPORTANT:
The 4 contacts connector should be connected properly so that the white
o-ring is not visible and a clicking sound is heard.
PAY ATTENTION:
If the 4 contacts connectors are not connected properly, the pump will
not operate properly.
2
Connect the transformer connector to the
matching connector from the sensor and
plug the transformer into the electricity
socket.
FROM THE TRANSFORMER TO THE SOAP DISPENSER
3
Wait about 10 seconds before placing your
hands within the sensor range to avoid
adjustment mode.
10
SECONDS
ABOUT
