17
16
BATTERY REPLACEMENT FOR LIQUID SOAP DISPENSER
Battery models only
When the battery weakens, the LED indicator light will blink at a constant rate when the
user’s hands are within the sensor range. The battery must be replaced within two weeks.
To replace the battery in battery models:
1. Carefully open the battery box, use a 2.5 mm Allen key
2. Replace the used batteries with new D batteries
3. Close the box.
NOTE: Do not mix used batteries with new ones.
Important: Spent batteries should not be disposed of with normal household
waste. Contact your local authority for information on waste disposal and
recycling.
MAINTENANCE
Care and cleaning of chrome and special finishes
DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives, or their like.
Use of any prohibited cleaning or maintenance products or substances could damage the
surface of the soap dispenser. For surface cleaning use ONLY soap and water, then wipe dry
with a clean cloth or towel. When cleaning bathroom tiles, the soap dispenser should be
protected from any splattering of harsh cleansers.
Disassemble of the soap pipe from the pump
The soap pipe can be disconnected from the soap pump by a simple slide & pull action. The
sliding ring of the quick connection fixation nipple on the pump should be pulled down. It
releases the open end of the soap pipe which can then be easily pulled out.
Filter cleaning instructions (foam dispenser only)
This soap dispenser is provided with a foam filter. It is recommended to clean the filter every
six (6) months.
If the soap supply has decreased, this may be caused by the clogged filter. The filter can be
cleaned as follows:
1. Use a wrench to unscrew the quick connection fitting from the foam compressor and
pull out the filter housing.
2. Remove the filter from the housing.
3. Replace the filter (recommended) or wash it under running water for a temporary fix.
4. Reassemble the parts.
