background image

When the 
med time arrives, the

auto light will turn “off
and the light above the

 button will illu-

minate indicating that

the brewing process has

begun.

In this mode of opera-

tion, the coffee will be

kept warm for two hours.

After that time, the

heating mechanism will

shutoff automatically

(see section Automatic
Shut-Off and Warm

Keeping).

 

 Feature

The 

 Serve feature is

 answer to the

impatient coffee drinker’s

clamor for a quick cup of
coffee! This device automa-

tically stops the flow of

brewed coffee through the

filter cone if the glass carafe

is removed from the

warming plate during the

brewing cycle. You have

about 20 seconds between

the removal of the carafe

and it being reinserted back
onto the warming plate.

The 

 Serve device

closes off the filter cone so

effectively that there is

virtually no coffeedrip onto

the warming plate. Once
the carafe is replaced, the

brewing process and the

flow of coffee into the
carafe can be resumed.

CAUTION

If the coffee DOES drip

onto the warming plate

after the removal of the

carafe, it is usually an indi-
cation that the small black

seal in the filter holder is

missing or defective.
In this case call the 

Consumer Service Depart-
ment at 
It is also possible that too
much ground coffee has
been placed in the filter

paper. This causes the

water that jets into the filter

cone to overflow between

the filter and the sides of
the filter cone.

If this blockage and

subsequent dripping does
occur, put the glass carafe

immediately back onto the

warming plate, and allow the
full brewing cycle to run its

course. Do not swing out the
swivel filter until the brewing

process is completed.

POWER FAILURE
BACK-UP

In case of a power surge/

and or failure, an electronic
device will keep all func-

tions stored up to 6

seconds.

During such an interruption,

the display panel and all the

indicator lights will go out.

When the power returns,
the indicator lights will

illuminate and the display
panel will show the correct

time.

If the power failure lasts
more than 6 seconds, the

machine will switch “off
completely. When power

returns, both the clock time

and the pre-programmed
time will flash. In this case,

the clock time and all the
functions must be reset.

CLEANING

 Always unplug this

appliance before clean-

ing. Clean the filter

basket, carafe and lid in
a solution of warm water
and mild liquid soap.

These parts can also be

placed in the upper level

of your dishwasher away

from the heating ele-

ment for safe effective

cleaning.

 Never use scouring

agents.

 Never immerse the

appliance itself in water.

To clean, simply wipe off

 a soft, damp cloth.

 Never use a cloth to

clean inside of the water
chamber, as this might
leave fuzzy deposits in

the chamber. Just rinse
with cold water periodi-

cally.

 OF THE

The coffeemaker must be

decalcified regularly. The

frequency depends on the

hardness of your water and
how often you use the

coffeemaker.

Summary of Contents for IL Caffe Bistro 867


















Reviews: