Krups ESPRESSO NOVO 3000, Instructions For Use Manual

Page: 15 / 17

15
auto cappuccino accessory turn the selector
to the
O position.
•
After use, remove the flexible tube from the
container.
•
Once this operation is completed, clean the
outlet nozzle with a damp cloth.
We recommend that you regularly dismantle
the auto cappuccino accessory and clean it
with water, a little non-abrasive dishwashing
liquid and a small brush. Rinse and dry before
reassembling it
(38) .
Be careful to mount the flexible tube the
right way:
engage the straight cut end into
the auto cappuccino accessory.
. Brewing head gasket
From time to time this gasket must be
cleaned :
• Put the filter basket in the filter holder and
place the filter holder in the machine.
•
Place a container under the filter holder.
• Turn on the appliance.
•
Turn the selector to the setting .
• When the hot water starts to filter through,
turn the filter holder slowly from left to right
so that the water filters through between
the gasket and the filter.
Descaling
• Descaling of your espresso machine should
be done fairly frequently with citric or
tartaric acid.
The guarantee does not include espresso
machines which do not function, or do
not function properly, because descaling
has not been carried out.
However, we would advise you to use the
Krups descaling solution which is available
from Krups. Descaling depends on the
hardness of the water, but also on the
frequency of use.
- Then follow the following method:
•
Unscrew the grid from the brewing head of
the appliance and clean it.
•
Dissolve 2 tsp/10 ml of the descaling product
or a packet of KRUPS descaling solution, in
17 oz/510 ml of lukewarm water and pour
the whole batch into the empty water
container.
•
Place a container under the brewing head.
Run through about 1/3 of the liquid
immediately, setting the selector to the
position
(10).
•
Stop the appliance, leaving the position (10)
engaged and wait for 10 - 15 minutes to
allow the descaler to take effect.
•
Next, start the machine again and allow the
rest of the liquid to run through.
•
Then rinse with two water containers of
fresh water and replace the grid on the head
of the appliance (see section on “Cleaning
the Appliance”).
Problems, probable causes and
how to correct them
Problems Probable causes Corrective actions
Espresso not hot Cups, filter and Preheat the
enough filter holder accessories (cups,
are cold. filter, filter holder)
See paragraph
«Preparing an
espresso».
Coffee leaks The filter holder See paragraph
around the filter is not mounted «Preparing an
holder correctly or has espresso».
not been tightened
sufficiently.
There are coffee
Clean around the
grounds on the filter and the
edge of the filter gasket.
The brewing head Clean the gasket
gasket is dirty. with a damp cloth.
The brewing Contact an
head gasket approved Krups
is defective service centre.
Pump is very noisy No water in the Fill the water tank.
water tank.
Water tank incor- Press firmly down
rectly mounted. on the water tank.
Coffee grounds too Use fresh coffee
old or very dry
and the pump can-
not produce
pressure.