D
E
FR
N
L
IT
E
N
17
ENGLISH
KRUPS
SERIE EA9000
16
n
When your machine displays this screen to you, or when you have performed the water hardness
test, you must indicate the number of red and green zones, using the touch screen. If the stick
shows 2 red zones and 2 green zones, press the first two red squares and the last two green
squares on the touch screen. The screen will then show an identical representation of your stick.
If you move home or if the quality of your water changes significantly, you can also reset the water
hardness at any time.
3.2 Initial settings
n
When using the machine for the first time, you will be prompted to configure various settings.
Follow the indications displayed on the screen. The aim of the following paragraphs is to give you
a few visual cues.
3.3 Configuring the settings
n
Switch on the appliance by pressing the ON/OFF button (1). A welcome message is displayed on
the screen, followed by the “Language” setting menu. After each selection, you can go back by
using the symbol. Configure the other settings by following the indications on the screen.
The appliance will also require you to set the following parameters:
HOTLINE NUMBER FOR COUNTRY OF RESIDENCE
n
This number is associated with the country you have selected. However,
you can change it and it may be changed at any time.
LANGUAGE
n
Your machine has a touch screen.
n
Select a display language by pressing the arrows until
“Hello”
appears
in the language of your choice.
n
Press
OK
to confirm.
INSTALLING THE APPLIANCE
n
Place your machine on a stable, flat, heat-resistant surface away from water splashes and sources
of heat. Ensure that the location chosen is sufficiently well ventilated, as the appliance gives off
heat. Please do not place the appliance on surfaces such as marble. Remove the protective films
from the display and grids.
3.1 Before first use
n
Before using the appliance for the first time, check the hardness of your water so that you can set the
appliance accordingly. This operation should also be carried out when you use your machine in a place
where the hardness of the water is different or if you notice a difference in the hardness of the water.
To check the water hardness, use the stick supplied with your machine or contact your local water
authority.
Measuring the water hardness
n
Fill a glass of water and immerse the stick in it for 5 seconds. Wait for a minute before reading the water
hardness. You will be asked for the hardness class observed (from 0 to 4) during the initial setup of the
machine. The red zones on the stick indicate the degree of hardness: class 0 = no red zone, i.e. your
water has a very low mineral content. Your water is more or less hard depending on the number of red
zones. The details of the classes are given in the table below:
Degree of
hardness
Class 0
Class 1
Class 2
Class 3
Class 4
° dH
< 3°
> 4°
> 7°
> 14°
> 21°
° e
< 3,75°
> 5°
> 8,75°
> 17,5°
> 26,25°
° f
< 5,4°
> 7,2°
> 12,6°
> 25,2°
> 37,8°
Appliance
setting
0
1
2
3
4
0
1
2
3
4
The water hardness classes for the initial setting of the appliance (section 3.2)
Danger:
Connect the appliance to an earthed mains socket. Voltage 220 - 240V. Failure to do
so means that you run the risk of fatal injury due to electricity! Respect the safety
guidelines (see section “Safety guidelines”).
FIRST USE
3
