30
Cleaning the "one touch cappuccino" block
To carry out this cleaning programme, you will need two containers (minimum 600 ml) and
some KRUPS cleaning liquid.
Turn the block button clockwise as far as it will go.
You can carry out the cleaning:
- By pressing the
"Prog" button
→
Maintenance"
→
"Block Cleaning"
. Follow the instructions
on the screen.
Dismantling the "one touch cappuccino" block
In addition to rinsing, it is necessary to clean the block after each use.
To dismantle the block, follow these instructions:
Remove the plastic connection pipe from the block
Fig. 14.
Press the button located above the block, which detaches it and allows you to slide it down to
unhook it
Fig. 15
.
Remove the settings button
Fig. 16
.
Remove the black plastic casing from the shell
Fig. 17
.
Remove the air end piece: this is the metal part located above the black plastic casing. Also
remove the plastic part from underneath
Fig. 18
. The block is now completely dismantled
Fig. 19
.
Once the parts have been washed and dried, put them back into place, and fit the block back
onto the machine
Fig. 20
.
Automatic descale programme for the steam circuit
Caution:
if your appliance is fitted with our Claris - Aqua Filter System cartridge, please
remove this before descaling.
The appliance will tell you when the descale programme is required. The frequency at which
this programme needs to be run depends on the quality of the water used and whether the
Claris Aqua Filter System filter is used or not (the more limescale in the water, the more
descaling is required).
Important:
you do not have to perform the descale programme immediately when the
appliance requests this; however, you should do this as soon as possible. If
descaling is delayed, an alert message
will remain on the screen until the
operation is performed.
Follow the instructions on-screen. It is also possible to launch descaling via the maintenance
menu.
To carry out this descaling programme, you will need a container that can hold at least 0.6 litre,
which must be placed under the One Touch Cappuccino block, and a sachet of KRUPS
descaling agent (40 g).
The automatic descale programme includes three phases: one descaling cycle and two rinse
cycles. The programme lasts approximately 20 min.
Important :
if there is a power cut or you disconnect your appliance, the cycle will relaunch
the stage in progress when the incident occurred; this operation cannot be
delayed. Make sure the entire cycle is completed to remove any traces of
descaling product that may be hazardous to your health.
!
!
!
IFU_KR_EA85_EO_0A17613_EA85 10/09/13 11:33 Page30
