Kruger&Matz KM1908, Owner'S Manual, Page: 32 / 156

32
Owner’s manual
EN
Handling the Remote Control
• Remove the batteries if the remote control is not going to be used for an
extended period of time.
• To avoid possible failure, read the following instructions and handle the remote
control properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under the direct sunlight or near sources of
excessive heat.
• Do not use caustic cleaners (porcelain, stainless steel, toilet, or oven cleaner
etc.) on the remote, as it may suffer damage.
Note:
Remove the battery from remote control handset when it is not to be used for a
long period. Otherwise it can be damaged due to leakage of battery.
Installation of batteries
1. Open the battery cover.
2. Insert 2 AAA batteries with correct polarity
(+/-) as indicated.
3. close the battery cover.
Remote Control Operation Range
Point the remote control to the unit
no more than 6 meters from the
remote control sensor and within 30°
horizontally and 30° vertically of the
front of the unit. The operating distance
may vary according to the brightness of
the room.
Note:
• Make sure that there is no obstacle between the
infrared remote sensor of the unit and remote control,
as the remote controllable range may decrease
• Do not expose the infrared remote sensor to direct
sunlight or other strong light, such as inverter
fluorescent light.