21.
I N STA L L G L A S S D O O R G U I D E
Refer to the separate installation instructions for the door guide that is included with your
order. Once installed, return to this document for next steps.
Check for any interference due to an uneven floor by
sliding the panel back and forth.
If necessary, adjust the height of the panel by loosening
the set screws at the bottom of each trolley with a 1/8”
allen wrench. Trolleys are shipped in the up position.
After the panel height has been adjusted, tighten the
trolley screws by hand with a 5/32“ allen wrench on the
backside of the panel.
Insert a 5/32” hex bit into a 1/4” socket on a torque
wrench, and torque trolley screws to 108 inch-lbs (9
ft-lbs).
If additional vertical adjustment is required, unhang the
door panel, remove the track cover, and adjust the
track up or down as needed.
20.
A DJ U ST PA N E L H E I G H T
1
2
3
4
2
4
