Krone Vario Pack 1510, Operating Manual, Page: 29 / 100

IV - 3
Operation
Barrel-shaped round bales can cause
damage to the floor conveyor. Distorted
and thick round bales are detrimental to
proper silage production.
4.4 Wrapping and Depositing Bales
• Start tying / wrapping procedure (see Chapter 6) ,
continue baling material pick-up until tying or wrapping
material is pushed into the bale chamber by the baling
material and picked up by the round bale, maintain
the nominal speed of 540 rpm when doing this,
until the wrapping process is complete.
• Stop the towing vehicle until the tying or wrapping
procedure has been completed.
• Eject the round bale from the bale chamber.
Always fully open the rear flap as the cylinders
must be fully extended to generate the pressure for
the floor conveyor tension.
• Always close the bale chamber and start the next
baling process.
4.5 After Baling
Slacken the bale chamber floor conveyor.
After baling work has been completed, the front and rear
floor conveyors must be slackened.
Rotate the shut-off tap (1) of the control valve (2) from
position “b” to position “a”.
The floor conveyor pressure cylinders are pressureless.
VP-1-036
2
a
b
1