Krone 1 000 245, Original Operating Instructions, Page: 88 / 108

Maintenance
88
12.7 Replacing the tines (in case of repairs)
I
II
2
1
SWN1400036_3
10
9 7
4
3
II
1
2
8 7
6
4
I
3
5
6
5
8 7
6
4
I
3
5
Fig. 46
1 Tines 2 Tine arm
3 Locknut M12 4 Base
5 Tine holder 6 Disc 13 x 35 x 5
7 Detent edged washer SKB 12 8 Hexagon head screw M12 x 85 10.9
9 Hexagon head screw M12 x 100 - 10.9 10 Deflection sheet
Adhesive (high-strength)
(order no. 938 627 0)
• To remove the broken tine, remove all tines in front of the broken tine.
• Remove the broken tine.
Mounting new tine
• Insert tine holder into tine. In doing so, make sure that the tine holder is positioned
according to the figure.
• Slide tine with tine holder on tine arm.
• Guide hexagon head screw with detent edged washer and disc from below through tine
holder and tine arm.
• Apply adhesive (high-strength) on threading overhang of hexagon head screw.
• Mount support, locknut and deflection sheet, if necessary.
• Raise the tines at their end and tighten locknut with tightening torque = 95 Nm.
• Proceed with all tines as described above.