Before calling service:
Problem
Caus
e
How to fix it
The machine is too noisy
The machine does not work:
The machine is turned
on, but does not cool:
Fittings do not seal properly
There is a fallen
object in the machine.
There is a fallen object
in the area of the fan.
The power cable is
not connected.
Socket does not work.
The main switch is not
turned on or the
thermostat is set to ,,0 ”.
Ventilation holes
are covered.
The machine has a
dirty condenser.
The tube is not
inserted correctly.
damage to the tube
Remove the object that is not in contact with
the cooling machine.
Remove the object from the fan area.
Connect the power cord into the socket.
Turn on the power switch and set the
thermostat to the desired value.
Remove anything from the vent holes.
Remove the coarse dirt and wipe off the dust.
Pull out the tube, check for any sharp edges,
and if there are, cut with knife.
Pull out the tube and shorten 2cm.
If, after the above recommended checks the fault
still persists, please contact customer service.
Do not forget to specify the following:
type of defect
type of product
product serial number (listed on the label)
Ordering parts:
ALWAYS USE ORIGINAL PARTS.
The manufacturer or supplier does not take any
res-ponsibility for parts which are not original or re-
commended by the manufacturer.
Technical specifications:
The technical label is located on the external front side
(under the control panel) of the machine or on the inside
divider. The CWP -100, CWP-200, CWP 300, CWP - 200
mobile and CWP-300 mobile have the label on the
outside shell on the front of the machine.
7
Summary of Contents for AS-110
Page 1: ......
